boiler load

After computation, temperature change rate can been directly determined according to the unit operation time when the boiler starts up, blows out and changes load.

经过推导计算，得到直接根据机组运行时间的长短来决定机组启停炉及变负荷时的温变速率。

Mixing of coal and wood can also meet full boiler load with 3 mills in operation.

混合煤炭和木头可能也遇见与运转中3个的磨房的充分的锅炉装载.

In-furnace average temperature correlates relatively well with boiler load and main steam pressure.

炉内平均温度与机组负荷和主汽压力的相关性较好；

The influence of primary air velocity, excess air coefficient, boiler load, auxiliary air distribution and tertiary air on NO, emission was investigated under both Horizontal Bias Combustion ( HBC) and Vertical Bias Combustion ( VBC).

该文分别在水平和垂直煤粉浓淡燃烧方式下，进行了一次风速、过量空气系数、锅炉负荷、二次风配风方式以及三次风量等因素对电站锅炉NOx排放影响的试验。

Under the same secondary air distribution mode SW will increase with a reduction in boiler load. The maximum thermal deviation factor of the reheater will increase with an increase in SW value.

在同样的二次风配风方式下，SW随锅炉负荷的降低而增加，再热器的最大热偏差系数随SW增加而增加。

In single fuel mode full boiler load can be achieved on coal or wood.

在唯一燃料方式充分的锅炉装载在煤炭或木头可以达到.

The study on heat load forecast of the heating boiler house

供暖热水锅炉房的热负荷预测

Calculation and Analysis of Wind Load for Boiler Steel Structure Design Used in Abroad Projects

国外工程中锅炉钢结构风荷载的计算及分析

The present paper describes a boiler combustion system suited for load changes.

本文介绍了适用于大负荷扰动的锅炉燃烧控制系统.

The influence of the supporting beam depth, the thermal coefficient of the material and the heat exchange coefficient on the maximum principal tensile stress in the boiler-supporting beam under the load of the temperature field is analyzed as well.

同时分析了支撑梁在该温度场作用下支撑梁宽度、材料的导热系数、梁表面热交换系数对梁内最大主拉应力的影响。

Online calculation of heat to power output efficiency of thermal generator set is important for the load coordination control in the CFB boiler thermal generator set.

为解决循环流化床锅炉发电机组负荷变化时的机炉协调控制问题，需要对发电机组的热功效率进行在线计算。

Numerical simulations were carried out to investigate the in-furnace combustion parameters at 1000/ 0 BMCR ( boiler maximum continuous rating) load of pre-and post-retrofit cases.

用数值模拟的方法对改造前和改造方案在10000/BMCR负荷下的炉内燃烧参数进行研究。